Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Polyfloor

Print this page Save this page as a PDF Product enquiry

Description:

Polyfloor is manufactured from a marine quality urethane that provides outstanding chemical, abrasion, corrosion and water resistance.  To be used in extreme environmental situations for maintenance, protection and durability.

Features:

  • Excellent abrasion resistance on floors
  • good chemical resistance
  • Resistance to atmospheric exposure - salt air
  • Actively inhibits corrosion over Tetracure P10
  • Good solvent resistance

uses:

Polyfloor is used as a single pack floor-coating over Acid Etched concrete floors, asphalt courtyards, tennis courts, driveways, plywood, particle board, pine, custom wood, Harditex fibre cement board on flooring, etc.

Preparation:

Always Acid Etch new and existing old concrete.  Wash with clean water or waterblast clean, completely removing all loose sand, cement etc.  when dry vacuum up loose dust or use wet vacuum.

Thin first coat 25% with White Spirits.  Allow 4-6 hours then apply 2 coats as supplied.  allow 8 hours between coats.

For best results under all steel, use 2 coats Tetracure P10 Primer to sandblasted steel to Swedish specifications Class SA 2.5 Swedish Standards SIS 05-5900:1967.

Application:

Using roller, brush, airless spray, pressure pot spray

Brush / rolling - apply 1 coat.  allow 4-6 hours.  apply second and third coast as required.

Thinning & Clean Up: Use White Spirits / Turps / Brush Wash.
Coverage: 8-12m2 per litre per coat, dependint on substrate type
Colours: White and all B.S. colours available
Packaging: Supplied in - 1, 2, 4, 10, 20 Litre steel D.G. Pails
N.Z. Dangerous Goods Class: Flammable Liquid, 3B


Warning:

Use only with adequate ventilation.  use suitable respirator that will extract solvents.  Observe new Occupational safety & Health (O.S.H.) Instructions.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.