Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Ultraglaze

Print this page Save this page as a PDF Product enquiry

Description:

Ultraglze is a two pack exterior / interior clear coating designed for flooring, walls, factories and step coatings.  Clear films have high quantities of ultra violet protective additives and are tough, resilient and non-yellowing with exceptional exterior durability.

Uses:

Ultraglaze systems provide a very hard durable finish with high resistance to a wide range of chemicals and are particularly suited to coat over Aquepoxy floors, seamless flake flooring, interior and exterior, glaze coating for hi-build acrylic systems, coating over bricks, blocks and walls, particle board flooring, etc.

Substrate Temperatures:

Do not apply below 10'C.  At this temperature cure rate will be considerable reduced.

Not Recommended:

Application to damp surfaces.  Immersion, alkalies or solvents.

Handling Precautions:

Solvent and resin fumes can be harmful and can contaminate foodstuffs.  provide and wear suitable respirator and protective clothing when spraying. 

Warning:

Contains Isocyanates.  when sprayed this product may be harmful by inhalation.  do not breathe vapour or spray.  Avoid contact with skin or eyes.  Wear protective clothing, gloves, eye and face protector including suitable breathing protection such as an air supplied respirator or hood.

Flash Point:

24'C contents flammable - Gives off vapour.  Keep well away from heat, sparks and flame.

N.Z. Dangerous Goods:

Class 3B

Mixing Ratio:

By volume

Mix 5 Litres Part A Resin
To 1 Litre Part B HArdener


Small Quantity:

Mix 1 Litre Part A resin
To 200 mls Part B Hardener


Important to keep correct accurate mixing ration by volume to ensure proper curing and hardness.

Minimum Application Temperature:

10'C

Pot Life:

25'C 50% relative humidity - 2 hours.

Dry Time:

25'C 50% relative humidity

Surface Dry: 1 Hours
Hard Dry: 2 Hours
Re-coat: 3 Hours


Coverage Rate:

Walls 8m2 per litre per coat 1 coat minmum 2 coats recommended
Floors 4m2 per litre per coat 3 coats minimum 2 coats recommended


Notice:

For correct material quantites, divide total area by two (3 coats - 2m2 per litre coverage).

Film build:

Wet:

Walls:

Floors:

125 microns (0.005) per coat

250 microns (0.010) per coat

Dry:

Walls:

Floors:

50 microns (0.002) per coat

100 microns (0.004) per coat



Thinning:

Thin 10% for spray application only using Ultraglaze Thinners.

Clean Up:

A.P. thinners, Ultraglaze Thinners.

Packaging:

Part A - 5 Litre cans

Part B - 1 Litre cans

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.