Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Epoxyflex

Print this page Save this page as a PDF Product enquiry

Description:

Epoxyflex is a 2 pack high viscosity thixotropic adhesive epoxy filler/jointing compount.  When A and B are mixed it gives a strong permanent flexible filler and bond.

Features:

Epoxyflex adhesion is outstanding even on damp surfaces.  Water can be applied to the surface to assist smoothing and finishing, and will prevent surface tack.  Cures well even around 5ºC in damp conditions.

Uses:

Epoxyflex is used to repair all types of concrete surfaces, on tile roofs, concrete floors and under Armepoxy, Floorkote systems and fibrecement decks.  It is ideal for reinforced jointing on harditex and fibrecement where a fibreglass tape is recommended.  Epoxyflex is used extensively as an adhesive for bonding all types of tiles.  It's also suitable for vertical areas as it will hold tiles in place.  It provides an excellent waterproof system for wet areas.

Mixing:

Ratio by volume, Equal Parts A and B, 1 to 1

Sealing:

Some surfaces may require Epoxy Sealers on timber, plywood or old concrete.

Preparation:

All concrete surfaces to be cleaned/waterblasted, and then must be Acid Etched.

Number of Coats:

2 flushing coats may be required

Coverage:

1 Litre of Compound will fill and flush 6 lineal metres 50 x 6mm x 6mm reinforced joint.

Dry Time:

4-10 hours

Clean up:

Soap and water or A.P. Thinners.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.