Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Harditex / Hardiflex Application

Print this page Save this page as a PDF Product enquiry
  1. Inspect site, ensure Harditex / Hardiflex has 3 mm gap.  Instruct Builder if necessary.
  2. Solvent seal total area of Harditex/Hardiflex.
  3. Apply 1 coat Flexicure 500 or Flexicure Powder mixed with Flexicure Resin (as per specifications).  Embed well into joint ensuring no air entrapment.  Allow to dry.
  4. Then apply second coat of Flexicure 500 and embed Fibreglass Tape into this coat.  Trowel smooth.  Allow to dry.
  5. Apply third finishing coat of Flexicure 500 to smooth finish.
  6. Inspect all joints using straight edge ensuring areas are all flush.  If not, then apply a further skim coat of Flexicure 500.  Allow to dry.
  7. Apply Acrylic Strongwall Sealer - colour as per final texture.
  8. Apply 1 scatter coat of Texturecoat Fine, Medium or Coarse - or Prekote P50.  Allow 20 minutes to dry, then apply using low air pressure second coat, heavy relief as required.
  9. Glaze if required.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.