Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Prekote Multifleck

Print this page Save this page as a PDF Product enquiry

Application Specifications:

Procedure:

  1. Apply to exterior harditex, 1 coat of Solvent Sealer over total area of sheets to bind all lamination of cement, wood, pulp, together.
  2. Apply flexicure Jointing System to all joints with polyproplene 75mm tyape.  Flexicure must be applied in 3 coats to achieve a suitable flush joint.  all joints to be checked with straight edge and a coat of Flushing Paste should be applied if they are not level.  Texture must not be applied until all joints are approved.
  3. Apply 1 scattered coat of Prekote P50 Texture with Resin 50 added.  reduce Air Pressure, and spray second coat heavy relief to achieve texture type required.  allow 6 hours to dry.
  4. Apply 1 coat of Strongwallsealer over total area with paint Aid No.3 Roller.  allow 2 hours to dry.
  5. Apply 2 coats of Multifleck Basecoat in correct colour - 2 hours between coats.  Using Paint Aid No.3 Roller, achieve a wet film build of 300 microns per coat.  3m2 per litre coverage.
  6. Apply Multifleck colour system at 3m2 per litre over total area, completely obliterating Basecoat.  Allow 24 hours to dry before the application of Glaze.
  7. Apply 2 coats of ultraglaze Clear U.V. System.  allow 4 hours between coats.  apply at 6m2 per litre per coat, achieving approximately 170 microns wet film build per coat.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.