Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Acrylic High Gloss

Print this page Save this page as a PDF Product enquiry


A premium grade 100% Pure Acrylic High Gloss affording maximum protection to weatherboard houses, hardiflex, harditex, concrete, over any Stucco sprayed concrete system, and elsewhere that a flexible abrasion resistant glossy acrylic is to be specified.


Prepare and prime following procedures as outlined in the data sheet "Preparation for Painting"

Typical Specification:

Apply 1 coat of 100% Pure Acrylic High Gloss.  This coat acts as an undercoat.  Apply by brush, speedbrush, roller or spray.  allow 3-6 hours to dry, depending on temperature (DO NOT apply in temperatures less than 10°C)

Glaze Coat:

As an option - even greater protection can be given by applying a final coat of Acrylic Glaze, which offers high ultra-violet and weather protection and makes cleaning even easier.  This finish only needs a coat of glaze every 8-10 years to continue long term protection.  Even existing paint still in good condition can be coated with glaze after first being chemically cleaned.  Glaze is easily applied by brush, speedbrush, roller or spray.


Acrylic High Gloss

Touch Dry ½ - 1 Hour
Recoat 3 - 6 hours
Thinning Not normally required
Clean up Water
Apply by Brush, Speedbrush, roller or spray
Coverage 6-10m² per litre


Acrylic Glaze

Touch Dry ½ -1 hour
Recoat Normally only 1 coat required
Thinning Do not thin
Clean Up Water
Apply by Brush, speedbrush, roller or spray
Coverage Approximately 18 m² per litre


Technical Service:

Free advice is available from Special Finishes Limited, or an Approved Applicator who would be pleased to give free advice and quote to apply this premium grade Acrylic High Gloss to your property.


Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.