Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints


Print this page Save this page as a PDF Product enquiry


Polycoat Maintenance Enamel is manufactured from a marine quality urethane that provides outstanding chemical, abrasion, corrosion and water resistance.  To be used in extreme environmental situations for maintenance protection and durability.


  • Good chemical resistance
  • Resistance to atmospheric exposure - salt air
  • Actively inhibit corrosion over Tetracure P10
  • Good solvent resistance


Polycoat Maintenance Enamel is used to overcoat steel, machinery, equipment, roofing iron, steel roof trusses, RSJ Beams, solvent drums, resin drums, forkhoists, tractors, trucks, farm machinery, flooring, walls.

For best results under all steel, use 2 coats Tetracure P10 Primer to sandblasted steel to Swedish specifications Class SA 2½ Swedish Standards SIS 05-5900:1967.


  1. Using roller, brush, airless spray, pressure pot spray, electrostatic spray.
  2. Spraying - apply 1 light dust coat.  Allow 5-10 minutes.  Apply 2 further coats - allow 5-10 minutes betwen coats.

Brush/Rolling - apply 1 coat.  allow 4-6 hours.  Apply second coat as requried.

Thinning & Clean Up:

Use Winter Thinners / turps / Spraying Thinners


8 - 12 m² per litre per coat, dependent on substrate type.


White and all B.S. colours available.


Supplied in -1, 2, 4, 10, 20 litre steel D.G. pails

N.Z. Dangerous Goods Class:

Flammable Liquid, 3B


Use only with adequate ventilation.  Use suitable respirator that will extract solvents.  Observe new Occupational Safety & Health (O.S.H.) Instructions.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.