Insect Killer Specifications
CTEM Bug Free - has been developed from outstanding
Technology.
this unique coating provides permanent elastomeric flexible
properties along with insect control that will provide long term
protection against all types of insects. CTEM Bug Free covers
any surface with a complete elastic durable protective film.
- CTEM bug Free is a safe, odourless, effective, insect control
coating.
- CTEM bug Free kills on contact - termites, spiders, flies,
mosquitos, roaches, ants, fleas and other flying and crawling
insects. it has been tested and proven effective on more than
130 various insect varieties.
- CTEM Bug free is an approved coating that has been Laboratory
Tested for over 4 years and has been declared totally safe to
humans and animals. the "killing power" of CTEM Bug Free will
provide protection for approximately 3 - 5 years, depending on
wheather the application is indoors or outdoors, or exposed to
extreme weather conditions.
- CTEM Bug Free provides excellent water resistance and superior
adhesion. It is highly resistant to atmospheric exposure,
infra-red and ultra-violet radiation, with exceptional toughness
and resilience.
CTEM Bug Free has been developed for the long term protection
and weatherproofing of concrete buildings, hotels, shopping
complexes, schools, hospitals, bungalows, comercial buildings,
galvanised iron roofs, steel, iron, bridges, waterproofing
concrete, block buildings, storage tanks, freezing works, oil
refineries, breweries, etc.
CTEM Bug Free can also be used on floors, walls, ceilings, in
domestic and commercial buildings such as housing, offices, hotels,
warehouses, schools, hospitals, restaurants, food processing
facilities, factories, farms, agricultural complexes etc.
CTEM Bug Free provides excellent protection against mould
fungus. It is ideal for hygiene areas with M.A.F.
Approval.
CTEM Bug Free can be used on super six fibre cement roofs,
plywood roofs, galvanised iron, concrete tiles, concrete, asbestos,
decromastic chip roofs and any surface that requires a of
mastic. On plywood roof systems, the use of embedded mesh
provides a total roofing system.
Flooring grade is produced as a non-slip durable floor coating
for steps, tennis courts, flooring, patios, decks, boats, ships,
swimming pool surrounds, workshops etc.
| Application: |
Brush, roller or airless spray |
| Clean Up: |
Water or Brush Clean solvent when dry |
| Thinning: |
Do not Thin |
| Drying Times: |
CTEM Bug Free Flexible Membrane will dry and can be recoated
after 2 hours at 20ºC - in cold or humid conditions. Allow 8
hours before application of second coat. |
| Coverage: |
4 - 6 m² per litre per coat (1 litre of CTEM Bug Free Flexible
Membrane per 1m@ achieve with 2 coats provides a dry film build of
0.500 - 0.600 microns |
Always apply 2 coats. Plywood roof systems - 4 coats
recommended with fibre mesh embedded.
Use correct Sealers on concrete and fibrolite, Tetracure P10
Primer to be used on galvanised iron, steel and bridge structures,
etc. always refer to preparation specification sheets before
any application.
New and old concrete must be waterblasted and the Acid
Etched. apply appropriate Sealer. Rust to be wire
brushed, then converted with Rid rust converter, then apply 1 coat
of Tetracure P10 primer. galvanised iron to be cleaned with
Chemocide Etch to remove oidaton, thn primed with Tetracure P10
4 litre, 10 litre, 20 litre plastic pails
Warranty / Liability
Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.