Floorseal is a two pack low viscosity Epoxy Sealer containing
adhesion promoters and surface wetting additives to ensure correct
wetting and penetration of acid etched concrete floors.
As a total dust sealer system for concrete and wood floors where
dust may create problems, sealer and adhesion promoter for Armepoxy
flooring system. Its uses ensures adhesion to porous concrete
and improves top coat coverage rates. Excellent sealer to
bind plywood laminations before overcoating.
Once coat only is required for a sealer to correctly prepared
dry concrete. Acid etching and waterblasting is essential,
and wet vacuum will assist with drying speed. allow 2 hours
before overcoating. Apply 2 coats for dust sealer.
Allow 2 hours between coats and 24 hours before heavy traffic.
| Touch Dry: |
2 Hours (can be used at temperature around 3'C) |
| Recoat: |
2 Hours |
| Pot Life |
1 Hour |
|
5 m2 per litre, depending on surface porosity |
|
Mix A & B, 1 to 1 equal parts. allow to stand 5
minutes, then stir and use. |
|
4, 10, 20, 200 Litres |
|
Special finishes A.P. Thinners, Cleansol, Armepoxy Solvent |
|
Class 3 |
Warranty / Liability
Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.