Clearflex H.V. Glaze

Description:

Clearflex is a flexibilised crystal clear finish manufactured from high quality Acrylic Polymer and is designed to seal and glaze a variety of surfaces.

Especially suited as a protective glaze coat over texture and splatter finishes.

Features:

• Hard wearing, easy to clean.
• Direct application to timber.
• Excellent gloss finish direct from spray gun.
• Superior blanch resistance.
• Suitable for interior or exterior use, with exception durability.

Uses:

Glaze coat over textured and special effects sufaces.  Suitable as a clear finish over funiture, hardboard, MDF board, and most metals.  Clearflex can be applied over lacquer and acid catalysed topcoats.

Application:

By spray, airlessspray, air mix, electrostatic spray.  Small areas can be applied by brush or roller.

Glaze Coating:

Apply 1 -2 coats with minimal thinning.

Timber Application:

1. Thin first coat 30-50% with A.P. thinners.  Allow minimum 20 minutes to dry, sand slightly to a smooth finish - dust free.
2. Apply 3 - 4 further coats maintaining a good wet edge.  Aallow to dry.  Sand between coats if required. (note: some porous timbers or composite board may require further coats)

Heath & Safety:

Wear Protective overalls, goggles and gloves.  Maintain adequate ventilation at all tims.  When spraying use an approved respirator with organic vapour cartridge.

Eye Contact:	Flush with copious amounts of water, or dilute boric acid solution and seek immediate medical aid.
Skin Contact:	Wash thoroughly with soap and warm water.

Warning:

Keep away from sparks and open flame.  Smoking should not be permitted in working areas.

Extremely Flammable Liquid - Keep out of reach of children - Avoid breathing vapours - Contains aromatic hydrocarbon solvents.

Dangerous Goods:

Flammable Liquid, 3A

Waring:

Observe  Occupational safety & Health Instructions (O.S.H)