Ultraclear 500

Description:

Ultraclear 500 (U.C. 500) is a two pack exterior/interior clear coating designed to overcoat Multifleck system, furniture, flooring, walls, factories and step coatings.  Clear films have high quantities of ultra-violet protective additives and are tough, resilient and non-yellowing with exceptional exterior durability.

Uses:

U.C. 500 system provides a very hard durable finish with gigh resisance to a wide range of chemicals and are particularly suited to coat over multifleck furniture, Aquepoxy floors, Seamless flake flooring, interior or exterior, Glaze coating for Hi Build Acrylic systems, Anti-Graffiti coating over bricks, blocks and walls, for long lasting wood finish on teak (boats) and particle board flooring, etc.

Substrate Tempeeratures:

Do not apply below 1-'C.  At this temperature cure rate will be considerably reduced.

Not Recommended:

application to damp surfaces.  Immersion in Acids, Alkalies or solvents.

Handling Precaurtions:

Solvent and resin fumes can be harmful and can contaminate foodstuffs.  provide and wear suitable respirator and protective clothing when spraing.

Waring:

provide adequate ventilation at all times.  Contains Isocyanate, A complete air assisted breathing apparatus to be used when spraying.

Flash Point:

24'C contents flammable

N.Z. Dangerous Goods Class:

3B, UN NO:1263

Mixing Ratio:

By volume, Mix 50 / 50 equal parts Part A to Part B

Small Quantity:

Mix equal parts Part A to Pat B (200 mils of each)

Important to keep correct accurate mixing ratio by volume to ensure proper curing and hardness.

Application for Spraying:

1. Mix U.C. 500 equal parts by volume.
2. Allow to stand for 5-10 minutes induction time.
3. Add 60-100% U.C.500 Reducer - thoroughly mix together.
4. Apply 1 even light coat - allow U.C.500 to tack off for 10-20 minutes before further application.
5. Then apply further coats utilising this same technique to obtain desired finish.

Warning:

Applicationof a thick filmbuild with coat after coat in quick succession can entrap solvent that would result in a softer film when cured.

Minimum application Temperature:

 10'C

Increase Cure:

In cold conditions addition of Activator Quickset will speed up cure times 1-2 hours.

Pot Life:

25'C 50% relative humidity - 2 hours.

Dry Time:

25'C 50% relative humidity

Recoat	20 Minutes
Surface Dry	4 Hours
Hard Dry	12 Hours

Coverage Rate:

Furniture / Multifleck	12-20m2 per litre
Walls	8-12m2 per litre	(1 coat minimum)
Floors	4m2 per litre	(3 coats minimum)

Film build:

Wet:	Walls: Floors:	125 microns (0.005) per coat 250 microns (0.010) per coat
Dry:	Walls: Floors:	50 microns (0.002) per coat 100 microns(0.004) per coat