Ultraglaze

Description:

Ultraglze is a two pack exterior / interior clear coating designed for flooring, walls, factories and step coatings.  Clear films have high quantities of ultra violet protective additives and are tough, resilient and non-yellowing with exceptional exterior durability.

Uses:

Ultraglaze systems provide a very hard durable finish with high resistance to a wide range of chemicals and are particularly suited to coat over Aquepoxy floors, seamless flake flooring, interior and exterior, glaze coating for hi-build acrylic systems, coating over bricks, blocks and walls, particle board flooring, etc.

Substrate Temperatures:

Do not apply below 10'C.  At this temperature cure rate will be considerable reduced.

Not Recommended:

Application to damp surfaces.  Immersion, alkalies or solvents.

Handling Precautions:

Solvent and resin fumes can be harmful and can contaminate foodstuffs.  provide and wear suitable respirator and protective clothing when spraying. 

Warning:

Contains Isocyanates.  when sprayed this product may be harmful by inhalation.  do not breathe vapour or spray.  Avoid contact with skin or eyes.  Wear protective clothing, gloves, eye and face protector including suitable breathing protection such as an air supplied respirator or hood.

Flash Point:

24'C contents flammable - Gives off vapour.  Keep well away from heat, sparks and flame.

N.Z. Dangerous Goods:

Class 3B

Mixing Ratio:

By volume

Mix	5 Litres	Part A Resin
To	1 Litre	Part B HArdener

Small Quantity:

Mix	1 Litre	Part A resin
To	200 mls	Part B Hardener

Important to keep correct accurate mixing ration by volume to ensure proper curing and hardness.

Minimum Application Temperature:

10'C

Pot Life:

25'C 50% relative humidity - 2 hours.

Dry Time:

25'C 50% relative humidity

Surface Dry:	1 Hours
Hard Dry:	2 Hours
Re-coat:	3 Hours

Coverage Rate:

Walls	8m2 per litre per coat	1 coat minmum	2 coats recommended
Floors	4m2 per litre per coat	3 coats minimum	2 coats recommended

Notice:

For correct material quantites, divide total area by two (3 coats - 2m2 per litre coverage).

Film build:

Wet:	Walls: Floors:	125 microns (0.005) per coat 250 microns (0.010) per coat
Dry:	Walls: Floors:	50 microns (0.002) per coat 100 microns (0.004) per coat

Thinning:

Thin 10% for spray application only using Ultraglaze Thinners.

Clean Up:

A.P. thinners, Ultraglaze Thinners.

Packaging:

Part A - 5 Litre cans

Part B - 1 Litre cans