Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Tetracure P10

Print this page Save this page as a PDF Product enquiry


Tetracure P10 is a single pack acid catalysed Vinyl Butyral System, reinforced with phenolic binders with high loadings of Tetroxy Zinc Chromate pigment, providing exceptional corrosion and adhesion properties; incorporating fast dry with excellent chemical and abrasion resistance.  Unique performance for metal pre-treatment and primers for outstanding long term protection.


  • use direct from can, single pot application (no mixing A& B, add Tetrasolve before use)
  • Exceptional corrosion and adhesion properties under adverse conditions, the only metal protection you need.
  • Excellent adhesion to aluminium, steel, galvanised iron, concrete, etc.
  • Tetracure P10 etches and fuses onto the substrate surface for outstanding adhesion.
  • Unique coating for concrete floors.

Typical Uses:

Automotive, buses, steel, cars, boats, concrete floors, RSJ's, aluminium, formica, galvanised iron - roofing, pulp and paper mills, tank lining to contain mineral oils and vegetable oils, oil refineries, power plants, petrochemical plants, hydro electric installations, gas plants, fertiliser plants, Dairy Companies, Freezing Works, structural steel, steel pipes, etc.

Physical properties:

Vehicle Type Vinyl Butyral / Phenolic Binder
Pigmentation Tetroxy Zinc Chromate


Roller, brush, conventional or airless spray, electrostatic spray.


Tetrasolve Reducer

Dilute 20-30% for brushing or rolling

Dilute 60-100% for spraying, adjust to suit spray equipment.

Clean Up: Use Tetrasolve Reducer
Coverage: 8m² per litre @ 120 microns wft.
Dry Film Thickness: 62.5 microns per coat
Dry Time:

Touch - 15 minutes

Hard - 4 hours

Recoat: 1-4 hours, depending on ambient temperature

Safety & Health:

Wear protective overalls, goggles and gloves.  maintain adequate ventilation at all times.  When spraying use approved respirator with organic vapour cartridge.

Eye Contact: Flush with copious amounts of water, or dilute boric acid solution and seek immediate medical aid.
Skin Contact: Wash thoroughly with soap and warm water.

Keep away from sparks and open flame.  Smoking should not be permitted in working areas.

Extremely flammable liquid, Keep out of reach of children, avoid breathing vapours, Contains aromatic hydrocarbon solvents

Dangerous Goods: Flammable Liquid, 3A
Warning: Observe New Occupational Safety & Health Instructions (O.S.H.)

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.