Special Finishes

Architectural and Decorative Coating Specialists

Colourtrend Acrylic PaintsColourtrend Acrylic Paints

Ultraprime Epoxy Primer

Print this page Save this page as a PDF Product enquiry


Ultraprime Marine Primer is a Two pack polyamide cured primer designed as an undercoat / primer for two pack topcoats.


  • Excellent adhesion to timber, GRP, concrete, fibrecement, aluminium
  • good flow and wetting properties
  • Good water resistance
  • Cures at temperatures down to 10ºC
  • tolerant of damp substrates
  • good sanding properties
  • Long pot life


Mix 4 parts A by Volume with 1 part B

Apply by roller, brush, conventional spray or airless spray.

Thin up to 10% if necessary with Armepoxy Solvent.  for airless spray use a minimum 0.018" tip and 2000 psi (15mPa) nozzle pressure.  Use Armepoxy Solvent for clean up.

Apply at spreading rate of approximately 12m²/lt to give a dry film thickness of 55 microns.

At 20ºC minimum recoat time is 16 hours (maximum recoat time is unlimited).  Pot life - 4 hours at 20ºC

Top Coating:

Ensure  Primer is thoroughly sanded and all sanding dust is removed.  Do not apply more than 75 micron dry film thickness of topcoat, otherwise adhesion could be affected.


Flammable.  Avoid contact with skin.  provide adequate ventilation in confined areas.  Wear protective clothing including face protection.  use suitable respirator.  keep away from children.

Warranty / Liability

Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.