Remove all existing paint, shot blast or diamond grind If
waterblasting only, then all concrete should be Acid Etched then
waterblasted clean, allow to completely dry.
Apply to dry concrete one coat of Optiseal, mix equal parts A
& B (1 to 1) by volume apply using a roller thoroughly flooding
total concrete area. Allow 2-8hours to cure.
Add Armepoy A & B into a 10-20 litre clean pail: Mix 3
parts Armepoxy 'A' with 1 part Armepoxy 'B' by volume.
(Please do not mix Armepoxy in the original 4 litre tins as
adequate mixing will not be achieved.) Apply one coat of
Armepoxy to total area usng a mohair roller. Allow 8-20 hours
to cure, do not exceed 20 hours before re-coating in hot
conditions. If this cure time is exceeded due to rain then
the Armepoy will require pole sanding with 80-120 grit sandpaper
before further application as Armepoxy becomes very chemical
resistant after 24 hours.
Mix Ultracoat in desired colour, equal parts (1 to 1) by volume,
apply 1-2 coats using a mohair roller and pole, roll out in two
directions then lay off downwards with the weight of roller only,
overlap each pass maintaining a wet edge. Allow 4-8 hours
between coats. Do not exceed overcoat times as adhesion could
be impaired.
Always refer to Special finishes if unsure or on unfamiliar
substrate types before commencing.
Warranty / Liability
Special Finishes (NZ) Ltd provides all the enclosed information in good faith but without warrantee and is to assist your application. However the use of this product being used is beyond their control. The manufacturers can accept no responsibility whatsoever for any damage or failure arising from its application or use. It is totally the responsibility of the user to insure that the product is suitable for its intended use.