Armepoxy Solvent

DESCRIPTION : Armepoxy is a two pack high build Epoxy coating. It is modified with a special flow promoter to ease application and does not contain solvents. This low toxic no fumes, makes Armepoxy an ideal system to coat inside floors in factories, freezing works commercial car parks. And in confined places.

FEATURES : Low toxic, no solvent fumes, high chemical resistance, abrasion resistant, hard durable finish. It has excellent adhesion to concrete, steel, timber etc., and will cure around 3ºC.

USES :
Armepoxy protective coatings are used extensively in commercial car park concrete floors, heavy industrial garage floors. Multi-colour seamless flake flooring systems, multi-chip coatings, Swimming Pools, steelwork, food processing areas, meat and dairy industries, garages, workshops, chemical and oil industry factories, and all types of industrial and commercial concrete floors.

It is particularly recommended where high performance, Heavy traffic use hard durable chemical resistant coating is required.

FINISH : Full Gloss/Anti-skid

APPLICATION : Roller, Brush or Airless spray

PACKAGING : Part ‘A’ - 3 litres in a 4-litre tin
                      Part ‘B’ - 1 litre in a 1 litre tin

FLASHPOINT : 150ºC

N.Z. DANGEROUS GOODS CLASS : Not Applicable

CAUTION :
Non Flammable.
Avoid contact with skin. Remove from skin immediately (using soap and water). Use suitable respirator.
Wear protective clothing, including face protection. Provide adequate ventilation in confined areas.
Keep away from children.

MIX RATIOS :
Volume ‘A’ and ‘B’ - 3 to 1
Important to mix accurately, 3 parts ‘A’ to 1 part ‘B’ Hardener by volume.

MIXING INSTRUCTIONS :
Stir each part thoroughly. Then add ‘A’ and ‘B’ together and stir until mix is homogenous.
Leave to stand for 3 minutes. Then stir and use.

SMALL QUANTITY : Mix to 1 litre ‘A’ Resin, add 340 mils of Hardener ‘B’.
THINNING: Do not thin Topcoats as colour floatation may occur.

POT LIFE : At 25ºC, 50% relative humidity - 1 hour Only mix sufficient Armepoxy that can be used within 30 minutes - as large mixed quantities will generate Exothermic Reaction and subsequent loss of material.

DRY TIMES :
25ºC, 50% RH - Touch Dry - 4 hours Hard Dry - 8 hours
Re-coat Minimum - 8 hours Re-coat Maximum - 24 hours

FILM BUILD : Wet - 160 microns Dry - 160 microns

NUMBER OF COATS : 2 coats not thinned - 3 coats on porous rough surfaces

COVERAGE :
Smooth surfaces - 6 m² per litre per coat - minimum of 2 coats required = 3m² per litre coverage
Rough surfaces - 4 m² per litre per coat - minimum of 2 coats required = 2m² per litre coverage

CLEAN UP :
Armepoxy Solvent
Special Finishes’ All Purpose “AP” Thinners
UC500 Reducer

WARNING : Observe new Occupational Safety & Health (O.S.H.) Instructions