Ultracoat

DESCRIPTION :  Ultracoat 100 is a two pack aliphatic reactive urethane for exterior/interior coloured coatings designed where excellent chemical resistance, moisture abrasion and resistance against petroleum solvents, oils, alkalies, acids, etc. is required. Coloured films have high quantities of ultra-violet protective additives and are tough, resilient and non-yellowing with exceptional exterior durability.

USES:
Ultracoat 100 system provides a very hard durable finish with high resistance to a wide range of chemicals. It is particularly suited to coat over machines, petrochemical plants, electro power plants, oil refineries, steel, equipment, automotive, food processing areas, freezing works, meat and dairy industries, hospitals, building complexes, industrial complexes, Aquepoxy floors, Flooring, interior or exterior, coloured coating over Hi Build Acrylic Systems, Anti-Graffiti coating over blocks, buildings and walls, for long lasting finish on boats, flooring, etc.

SUBSTRATE TEMPERATURES : Do not apply below 10ºC. At this temperature cure rate will be considerably reduced.

NOT RECOMMENDED : Application to damp surfaces. Immersion in acids, alkalies or solvents

HANDLING PRECAUTIONS :  Solvent and resin fumes can be harmful and can contaminate foodstuffs. Provide and wear suitable respirator and protective clothing when spraying.

WARNING Provide adequate ventilation at all times.
Contains Isocyanate - A complete air assisted breathing apparatus to be used when spraying.

FLASH POINT : 24ºC - contents flammable

N.Z. DANGEROUS GOODS CLASS : 3, UN1263

MIXING RATIO : By volume: Mix 50/50 equal parts Part A to Part B
SMALL QUANTITY : Mix equal parts Part A to Part B (200 mls of each) Important to keep correct accurate mixing ratio by volume to ensure proper curing and hardness.

APPLICATION - FOR SPRAYING :
1) Mix Ultracoat 100 equal parts by volume
2) Allow standing for 5-10 minutes induction time.
3) Add 60-100% U.C. 500 Reducer - thoroughly mix together.
4) Apply 1 even light coat - allow Ultracoat 100 to tack off for 10-20 minutes before further application.
5) Then apply further coats utilising this same technique to obtain desired finish.

WARNING - Application of a thick film build with coat after coat in quick succession can entrap solvent that would result in a softer film when cured.

MINIMUM APPLICATION TEMPERATURE : 10ºC

INCREASE CURE : In cold conditions addition of Activator Quickset will speed up cure times - 1-2 hours

POT LIFE : 25ºC 50% relative humidity - 2 hours

DRY TIME :
25ºC 50% relative humidity
Re-coat - 20 minutes
Surface Dry - 4 hours
Hard Dry - 12 hours

COVERAGE RATE :
Steel / Machinery / Automotive / Industrial - 12-20 m². / Litre
Walls - 8-12 m². / Litre
Floors - 4 m². / Litre (3 coats minimum)

FILM BUILD :
WET: Walls - 125 microns (0.005) per coat
Floors/Plant/
Machinery/Automotive - 250 microns (0.010) per coat
DRY: Walls - 50 microns (0.002) per coat
Floors/Plant/
Machinery/Automotive - 100 microns (0.004) per coat