Ultraglaze Solvent

DESCRIPTION : Ultraglaze is a two-pack exterior/interior clear coating designed for flooring, walls, and factories and step coatings. Clear films have high quantities of ultra violet protective additives and are tough, resilient and non-yellowing with exceptional exterior durability.

USES : Ultraglaze systems provide a very hard durable finish with high resistance to a wide range of chemicals and are particularly suited to coat over Aquepoxy floors, seamless flake flooring, interior and exterior, glaze coating for hi-build acrylic systems, coating over bricks, blocks and walls, particle board flooring, etc.

SUBSTRATE TEMPERATURES : Do not apply below 10ºC. At this temperature cure rate will be considerably reduced.

NOT RECOMMENDED : Application to damp surfaces. Immersion, alkalies or solvents.

HANDLING PRECAUTIONS : Solvent and resin fumes can be harmful and can contaminate foodstuffs. Provide and wear suitable respirator and protective clothing when spraying.

WARNING : Contains Isocyanates. When sprayed this product may be harmful by inhalation. Do not breathe vapour or spray. Avoid contact with skin or eyes. Wear protective clothing, gloves, and eye and face protector including suitable breathing protection such as an air supplied respirator or hood.

FLASH POINT :
24ºC - contents flammable
Gives off vapour. Keep well away from heat, sparks and flame

N.Z. DANGEROUS GOODS : Class 3

MIXING RATIO :
By volume:
Mix 5 litres Part A Resin
to 1 litre Part B Hardener

SMALL QUANTITY :
Mix 1 litre Part A Resin
To 200 mls Part B Hardener

Important to keep correct, accurate, mixing ratio by volume, to ensure proper curing and hardness

MINIMUM APPLICATION TEMPERATURE : 10ºC
POT LIFE : 25ºC 50% relative humidity - 2 hours

DRY TIME :
25ºC 50 % relative humidity

Surface dry - 1 hour
Hard dry - 2 hours
Re-coat - 3 hours

COVERAGE RATE :
Walls - 8 m² per litre per coat 1 coat minimum 2 coats recommended
Floors - 4 m² per litre per coat 3 coats minimum 2 coats recommended

NOTICE : For correct material quantities, divide total area by two (3 coats = 2m² per litre coverage).

FILM BUILD :
WET : Walls - 125 microns (0.005) per coat
Floors - 250 microns (0.010) per coat
DRY: Walls - 50 microns (0.002) per coat
Floors - 100 microns (0.004) per coat

THINNING : Thin 10% for spray application only using Ultraglaze Thinners.

CLEAN UP : All Purpose Thinners, Ultraglaze Thinners

PACKAGING :
Part A - 5 litre cans
Part B - 1 litre cans